If your processor is powering the keypads from its internal power supply that might have gone bad.In order to reply to a post or start a new thread, you will need to register: click the Register link above to proceed.To start viewing messages, select the forum that you want to visit from the selections below.
![]()
I have a few questions: 1) The processer seems to be working find. ![]() I see the green lights on many of the remote power modules and on the processor LCD panel it is two green lines moving in a circle. However, on my light switches there is normally a green light showing power to the switch. There is currently no green light at the switch and power does not appear to be getting to the switches. I had this same issue many years ago, but a reboot of the system fixed it. This time a reboot does not fix it. Lutron Homeworks Ers Software And RunLutron Homeworks Ers Download The SoftwareWhat could be the possible causes of this issue 2) Is there a way for me to download the software and run a diagnostics on the system without calling a dealer 3) The dealers in my area say they handle Homeworks QS, but my system is a Homeworks Interactive. How can I tell if the dealer is telling me the correct diagnosis c. ![]() If so check to make sure that box has power and is sending power out to the keypads. The processor appears to be working, the LCD panel show two green lines moving in a circle. So do you think the issue might be Keypad power supply What does this look like. The processor seems to be working with a green dashed line on them and I can see green lights on many of the remote power modules. Lutron Homeworks Ers How To Work OnBoth dealers I called are trying to sell me a whole new processor saying my processor is old (homeworks interactive) and they dont know how to work on it. They want me to buy a Homework QS which is convient for them since it costs 1,000 of dollars. How do I find a dealer that can work with the Homeworks Interactive. Also one dealer said my system was from the 1980s but my house was built in 2001. You need to check and see if your keypads are powered from either the processor or the remote power supply, If they are powered from the remote power supply and that goes bad you would have no leds lit on the keypads. The processor could be just fine but the buttons will not work without power to the keypad.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |